180mm x 90mm
WARNING - To Prevent Accidental Disengagement Of The Work Tool The Following Check Procedure Must Be Carried Out. This Procedure Must Be Followed Each Time The Engine Is Started Or When An Attachment Is Fitted.Do Not Operate This Machine Until You Have Positive Identification That The Coupler Pins Are Fully Engaged. Check For Engagement By:1. Tilt The Work Tool Down.2. Put Down Pressure On The Work Tool.3. Back The Machine Up And Make Sure There Is Not Any Movements Between The Work Tool And Quick Coupler Assembly.4. If There Is Movement, Disconnect The Attachment, Reconnect And Follow The Above Procedure. If Movement Persists Do Not Operate The Machine. Advise Your Supervisor Or Contact William Adams Service Department.